Step One

Outside Recess (Refer to the diagram below)

If fitting the blind outside the window, measurements (C) will need to be the same. To work out (C), simply minus (B) from (A) and divide the answer by two. Follow instructions for FACE FIXING.

Inside Recess (Refer to the above diagram)

Decide whether to FACE FIX or TOP FIX.

FACE FIX to fix the bracket to the window frame. TOP FIX to the lintel if the window is uPVC, or if there are any obstructions, e.g. window handles.

Step Two

Place blind in fitting position and tilt forward to show ladder controls. When fitting the brackets, you will need to have at least 5cm either side of controls.

Use cord control A to raise and lower the blind. The wand control B turns to adjust the slat angle

View from above

Step Three

Top Fixing
Measure the distance that any handles protrude from the frame. A. Mark this measurement on the lintel and use it to position the back of the bracket. Mark the position of holes B and screw bracket to lintel using screws and rawl plugs supplied.

Face Fixing

Position bracket with the swing arm facing towards you, and mark holes B. Screw bracket in place. Use rawl plugs if fitting to the wall.

WARNING: In the interest of safety, it is advisable to keep all pull cords and chain/bead cords out of the reach of children.

Step Four

Push swing arm anti-clockwise as far as it will go. Now clip the blind over the bracket, first easing the front lip of the headrail A in to place.

Step Five

Push swing arm clockwise until it locks in to place, firmly holding the blind headrail. 

Step Six

Use cord control A to raise and lower the blind. The wand control B turns to adjust the slat angle. 

When ordering your blind please remember to select which side of your blinds you wish the control placement to be situated. Picture depicts a left placement